Never store your Accessport in an area that experiences any noticeable levels of vibration, static electricity, heat shock, or excessive swings in relative humidity. Be careful not to drop your Accessport or any associated parts. Your Accessport may be damaged by improper storage or handling. In such cases, please contact Technical Support BEFORE attempting to the use the Accessport.
Cobb accessport v2 user guide professional#
If your Accessport or any associated equipment gets wet, professional repair may be required. Take care to prevent any liquids from coming in contact with the Accessport or any associated equipment. Never store your Accessport in an area that receives direct sunlight. When storing the Accessport, do so in a place where temperature is always between 0° and 115° F (-18° and 46° C) and a relative humidity below 90%. If the Accessport is not booting up correctly or the screen does not show everything correctly, turn the device off and move it to a cooler environment temporarily. The Accessport is thermally protected and will not function if the temperature reaches extremely high levels. Using the Accessport outside of these recommendations may result in damage. The Accessport is designed to be operated at temperatures between 32° and 95° F (0° and 35° C) and with a relative humidity below 90%. Technical support will instruct you on what to do next. brand new model year, new world market ECU, etc.). It is possible that you have an ECU type that we have never encountered before (e.g.
Closely inspect all connections to make sure nothing is out of place. Unplug the OBD-II cable from the vehicle and Accessport.Verify that the vehicle's ignition is turned to the "ON" position (not Acc.) before selecting the option on the Accessport.NOTE: The 10 log files can be a combined length of 2+ hours long.Īccessport will not communicate with vehicle. If datalogging is started when there are already 10 log files on the Accessport, the log file with the lowest numerical value will be automatically overwritten. NOTE: Up to 10 log files can be stored on the Accessport. The Accessport will display an error message if it cannot communicate with the vehicle. NOTE: The Accessport is only capable of datalogging while the ignition is turned to the ON position. If you receive this prompt, reduce the amount of monitors you are recording. NOTE: You will be notified if you have exceeded the recommended amount of recorded monitors in one datalog. Reset to Defaults – Restore the datalog list to the default list Sort Monitors – Sort the monitor list alphabetically, then reverse-alphabeticallyĬlear Monitors – Clear all monitors from the datalog list In there you will find the following options Press to find the Setup option for Configure Datalog. Pressing the button will save any changes you have made to the datalog list. You can make changes to the log list by highlighting a monitor and pressing the button to activate/deactivate it for logging. There is a default log list that includes a group of monitors put together by our in-house tuners. Only monitors with a green circle will be recorded while using the datalogging feature.
This list allows the user to enable or disable parameters for logging. Select "Install" from the Accessport menu by pressing the "OK" button in order to proceed with installation.
Cobb accessport v2 user guide free#
For keyless cars, make sure your feet are free from all pedals and press the start button one time. Turn off all in-car electronics (AC/heater fans/headlights/stereo, etc.) and make sure all doors are shut. Turn the key to the ON position but do not start the vehicle.Make sure the clasp on the OBD-II cable firmly engages with the port.Connect the small end of the OBD-II cable to the port in the bottom of the Accessport by pressing down on each of the two tabs to release the locks, then let go after firmly pressing the end of the cable into the receptacle on the Accessport.Plug the OBD-II cable into the port in the dash of the vehicle.The location may vary depending on the exact model of vehicle. Make sure the car is still in the off position. You will need the Accessport and OBD-II Cable to perform the installation.
0 kommentar(er)
